Strobepro XTC (Godox X1T-C) Radio Trigger Controller - Canon
Unleash the power of your speedlites off camera. The XTC allows full control of Strobepro X60C and X60M speedlites and 2017 studio strobes. Add the Strobepro XRC receiver to any of your Canon ETTL-II speedlites for full control, plus trigger other strobes as well. Finally, one system, one trigger.
The Strobepro Difference
Your Strobepro XTC is built to the same specifications as the Godox X1T-C, but with the added benefit of Strobepro's industry leading support. Strobepro is the largest distributor of Godox products in Canada. Give yourself peace of mind with Strobepro's helpful staff, 2 year warranty, and Calgary based service centre.
ETTL & HSS
You’ll have ETTL automatic or manual control if you prefer, all with full HSS at up to 1/8000s shutter speeds.
Make a System
The Strobero XTC transmitter paired with the XRC receiver gets all your Canon flashes off camera. Better yet, add Strobepro X60C or X60M speedlites and the receiver is built in already.
Focus Assist Beam
Don’t get stuck in low light. The dedicated focus assist beam switch allows you to quickly project a grid assist pattern if needed.
Add full control in up to 5 separate groups.
You’ll never have interference again with 32 channels.
328 foot range. If you find yourself in need of firing your flash a few blocks away, we’ve got you covered.
Considering that this was my second transmitter trigger in 15 months, I wasn’t that excited about having to purchase another one.
My first one didn’t work when I’m close proximity to the speed light. This one seems to work but I was three months out of warranty and the original hadn’t worked properly since I got it.
If you're using this close to the speedlites, please make sure you're in close range mode. Turn the power off, hold the test button, while holding turn the power on. You'll see the light blink and that means you're in close range mode. Once you turn the power off it will default back to regular distance mode. Please also make sure you have our latest firmware installed that can be found in the Help Desk.
I have used 5 Pocket wizard units and the xt triggers are much nicer to use. And TTL. To manual conversion is the greatest.
The trigger works great for the lights it is intended for. HSS works flawlessly. I am very impressed with no misfires. I do have a slight problem with the pass through mount on top of the flash. It works great with my Canon flashes, but I cannot seem to get it to work with my pocket wizards or elinchrome triggers.